Checking Insert and Eject, CD Module (MP2)

Checking insert and eject

Fault-tracing information
Check that nothing is in the way or inserted into the MD player.
Remedy as necessary.

Was a fault detected?

Yes - Remedy as necessary

No - Checking insert and eject

-------------------------------------------------

Checking insert and eject

If a disc with contents that cannot be read by the CD player, e.g. a CD-ROM, has been inserted, the disc may get stuck and the text "unreadable disc" is shown on the display.
1. Turn on the CD player and wait until the text "unreadable disc"appears in the display.
2. Remove the fuses for the CD player module (MP2).
3. Wait at least 10 seconds and then refit the fuses.
4. Turn on the CD player again and wait until the text "unreadable disc" appears in the display.
5. Press the Eject button
6. Repeat as necessary, 2-5 times.

Other information:
- For information on fuses, see the relevant wiring diagram.

Was a fault detected?

Yes - Remedy as necessary

No - Replacing the component

-------------------------------------------------

Replacing the component
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out
- No component, connector or wiring faults etc. should have been detected.
Try replacing the CD module (MP2).

Caution! A new CD module (MP2) is supplied without software. The gearbox control module (TCM) must be programmed when it has been replaced.

Other information:
- For information about programming and accessing or replacing the CD module (MP2), see MiniDisc / CD control module, replacing Service and Repair.

Was a fault detected?

Yes - Try replacing the CD module (MP2)

No - Exit fault-tracing

-------------------------------------------------