FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Antenna Module (ATM), Incorrectly Matched






Antenna module (ATM), incorrectly matched

Fault-tracing information
Diagnostic trouble code (DTC) ATM-0001 is stored if the antenna module (ATM) is not adapted to the same market as the car. For example an antenna module (ATM) for the Japanese market is installed in a car adapted for the EU, US or AUS.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the antenna module (ATM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs.
If the fault recurs, replace the antenna module (ATM).
If the fault is permanent, check that the radio wavebands and frequency settings are configured for the relevant market. This can be read off from vehicle communication for the central electronic module (CEM), reading off data for vehicle configuration, waveband and frequency settings radio. Replace the antenna module (ATM) if the radio is configured for the correct market.
Remedy as necessary.

Other information:
- To replace the antenna module (ATM), see Receiver AM/FM (ATM), replacing Service and Repair.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that all relevant frequencies are available.

Is the antenna module (ATM) working?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------