Signal Missing - Intermittent Fault

Signal missing. Intermittent fault

Checking component and wiring
Check cable between engine control module (ECM) #B46 and combined instrument panel #4 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information
- To connect the engine control module (ECM) breakout box, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box
- To connect the combined instrument panel breakout box, see Connecting the Driver Information Module (DIM) test box Connecting the Driver Information Module (DIM) Test Box
- For information about signals, see Signal specification Signal Description / Specification.

- For information about the combined instrument panel connector, see Driver Information Module (DIM) signal description Signal Specification, Driver Information Module (DIM).





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking component and wiring

FAULT FOUND - DONE

-------------------------------------------------