Connecting the Driver Information Module (DIM) Test Box

Connecting the Driver Information Module (DIM) test box

Special tools:
951 1463 Adapter 22-16-14 pin 951 1463 Adapter 22-16-14 Pin
951 1428 Breakout box 951 1428 Breakout Box
951 1499 Cable 951 1499 Cable
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428

Connecting the test box




- Ignition off
- Remove interior fuse 24 (11C/24)
- Loosen the combined instrument as described in Driver information module (DIM), replacing Driver Information Module (DIM), Replacing
- Release control unit connector.
Connect adapter951 1463 Adapter 22-16-14 pin 951 1463 Adapter 22-16-14 Pin (22-16-14-pin) to control unit connector and connect test box951 1428 Breakout box 951 1428 Breakout Box and wire951 1499 Cable 951 1499 Cable to adapter.
Alternatively connect test box981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 to adapter.
Disconnect the test box in the reverse order.





Additional information:
- To remove the combined instrument see Driver information module (DIM), replacing Driver Information Module (DIM), Replacing
- For information about signals and other values, see Driver Information Module (DIM) signal description Signal Specification, Driver Information Module (DIM).