Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Intermittent fault




- The fault tracing only applies to automatic transmissions
- Ignition off.
Check the signal cable between the central electronic module (CEM) terminal #1D and the gear selector assembly terminal #A3. Check for an open-circuit. Check for contact resistance and oxidation.
Remedy as necessary.

Other information:
- To access or replace the central electronic module (CEM), see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- To access or replace the lever module, see Gear selector lever assembly, replacing Gear Selector Lever Assembly, Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- For information about signals, see Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring And Terminals.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------