Gear Selector Lever Assembly, Replacing

Gear selector lever assembly, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the center console

S60R (B5254T4 engine)
Remove the center console. See Center console, replacing Center Console, Replacing.

S60 (other engines)
Remove the center console. See Center console, replacing Center Console, Replacing (-2004) or Center console, replacing Center Console, Replacing (2005-).

Removing the gear selector knob
Remove the gear selector knob. See: Gear selector knob, replacing, B5254T2, AW55-50/51SN Gear Selector Knob, Replacing.

Removing the top panel from the gear selector assembly
Remove the top panel. See: Printed circuit board gear selector assembly/top panel, replacing, B5254T2, AW55-50/51SN Printed Circuit Board Gear Selector Assembly/Top Panel, Replacing.

Removing the gear selector assembly and cables





Remove:
- the catch for the cable at the gear selector lever
- the cable from the end of the gear selector assembly
- the key lock cable. Pry out the yellow locking sleeve slightly. Lift the cable up from the gear selector assembly
- the 4 screws.

Removing the gear selector assembly stop
Transfer the gear selector assembly stop. See: Printed circuit board gear selector assembly/top panel, replacing Printed Circuit Board Gear Selector Assembly/Top Panel, Replacing.





Removing the solenoid
Transfer the solenoid to the new gear selector assembly

Installation

Note! For tightening torques, see: Tightening torque [1][2]Mechanical Specifications.

Installing the cables and gear selector assembly




Tighten to 25 Nm.

Install:
- the mechanical cable to the gear selector. Secure the cable with the catch
- the cable to the end of the gear selector assembly
- the key lock cable to the gear selector assembly.
Place the cable in the extracted locking sleeve the cable will be adjusted).

Initial setting of the key lock cable (adjusting)
See Key interlock cable, initial setting and adjustment Procedures.

Installing the top panel on the gear selector assembly
Install the top panel and boot. See: Printed circuit board gear selector assembly/top panel, replacing, B5254T2, AW55-50/51SN Printed Circuit Board Gear Selector Assembly/Top Panel, Replacing.

Installing gear selector knob
Install the gear selector knob. See: Gear selector knob, replacing, B5254T2, AW55-50/51SN Gear Selector Knob, Replacing.

Installing the center console

S60R (B5254T4 engine)
Install the center console. See Center console, replacing Center Console, Replacing.

S60 (other engines)
Install the center console. See Center console, replacing Center Console, Replacing (-2004) or Center console, replacing Center Console, Replacing (2005-).