Replacing the Control Module

Replacing the control module

Replacing the control module for locks and alarm (VGLA)

Preparations

Caution! Before replacing the control module, it is important to read out how the old control module is programmed. This is done in VIDA vehicle communication under the heading Reading programmed values. Read out and note the programmed values. After replacing, program the relevant data in the new control module. If the values cannot be read out, consult your closest supervisor/sales company/customer so that the new control module is configured the same as the old control module.

Removing the control module





Remove:
- the soundproofing panel on the driver's side. See: Dashboard Dashboard.
- the control module by pressing to the left.
Unplug connectors.

Installing the new control module
In reverse order.

Ordering software

Caution! In order to program the new control module, software must be ordered.

Order program for S/V 70 as described in 9438441.
Order software for C 70 as described in 9438436.