Dashboard

Dashboard

windscreen wipers




Nut M8, 13 mm.

Gutter




5 Torx 20 screws with washers.

The wiper motor mounting and the dashboard screws




2 10 mm nuts for the wiper motor mounting.
Connector
4 M6, 10 mm screws for the dashboard.

The left-hand side soundproofing panel




1 Torx 20 screw.

The glove compartment




6 Torx 20 screws.
The surround for the CD ROM player.

The right-hand side soundproofing panel




2 Torx 20 screws behind the edge of the glove compartment.

The dashboard screws in the passenger compartment




4 Torx 20 screws.
Lift the dashboard out of the car.

Valve housing




2 Torx 20 screws for the valve housing. The valve housing is located on the back of the dashboard.
Remove the damper control from the valve housing and pull it out.

Valve housing and air ducts




(The illustration shows the reverse of the dashboard).
3 Torx 20 screws.

Valve housing and air ducts




(The illustration shows the reverse of the dashboard).
2 Torx 20 screws.

Combined instrument panel trim




(The illustration shows the reverse of the dashboard).
Cable duct: 2 Torx 20 screws.
Combined instrument panel frame: 8 Torx 20 screws.

Frame center




(The illustration shows the reverse of the dashboard).
13 Torx 20 screws.

Cable harness routing




(The illustration shows the reverse of the dashboard).
2 Torx 20 screws holding the cable duct.
The cable harness is secured with clips. Marked with arrows.

Cable harness routing




(The illustration shows the reverse of the dashboard).
The cable harness is secured with clips. Marked with arrows.