Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking the signal cable
Check signal cable between combined instrument panel #A13 (breakout box #13) and generator #2 (D+) for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.

Other information:
- To connect the breakout box, see Connecting breakout box, Combined instrument panel Connecting the Breakout Box.
- For information about signals, see Connector A, #A1 - #A30 , Connector B, #B1 - #B16 and Connector D, #D1 - #D5.





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall connectors, components etc.
- Start the engine.
Read off the charging status by clicking on the VCT 2000 symbol. The parameter should display ON.





Is the value OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the signal cable

-------------------------------------------------