Power Steering Gear Overview

Power Steering Gear Overview






1 Right Tie Rod End

• Marked with an "R". Refer to => [ Make sure the correct tie rod end is installed on each side. ] Tie Rod.

• Check dust caps for damage and correct seating.

• Conical pin must be free of grease and oil.

• If necessary, clean using dry rag, do not use cleaning agents.

• Removing and installing, refer to => [ Tie Rod Ball Joint ] Tie Rod Ball Joint.

2 Nut

• 70 Nm

3 Spring Clamp

4 Boot

• Check for damage.

• Must not be twisted when toe is being adjusted.

5 Clamp

• Always replace if removed.

6 Tie Rod

• 100 Nm

• Removing and installing, refer to => [ Tie Rod ] Tie Rod.

7 Seal

• Replace when removing the boot. Refer to => [ Boot ] Boot.

• For the correct allocation, refer to the Electronic Parts Catalog (ETKA).

8 Power Steering Gear

• Removing and installing, refer to => [ Power Steering Gear ] Power Steering Gear.

9 Left Tie Rod End

• Marked with an "L". Refer to => [ Make sure the correct tie rod end is installed on each side. ] Tie Rod.

• Check dust caps for damage and correct seating.

• Conical pin must be free of grease and oil.

• If necessary, clean using dry rag, do not use cleaning agents.

• Removing and installing, refer to => [ Tie Rod Ball Joint ] Tie Rod Ball Joint.