2.0L TFSI Manual

Starter

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Torque wrench (V.A.G 1332)

Removing


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Disconnect the battery. Refer to => [ Battery, Disconnecting ] Battery, Disconnecting.

- Remove the air filter housing.

- Remove the cap - 1 - from the solenoid switch in - direction of arrow -.






- Release and disconnect the connector (terminal 50) - 1 -.






- Remove the nut - 1 - and disconnect the positive cable - 3 - from the solenoid switch.

- Remove the bolt at the top of the starter - arrow -.






- Remove the noise insulation.

- Remove the nut - 1 - from the bolt at the bottom of the starter.






- Remove the wire holder - 2 -.

- Remove the starter bolt - arrow -.






- Remove the starter downward.

Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Starter Overview ] Service and Repair.

- Connect the battery. Refer to => [ Battery, Connecting ] Battery, Connecting.