Gear Shift Unit
Gear Shift Unit
• Lubricate the bearing areas and sliding surfaces.
• Grease allocation, refer to the Parts Catalog.
1 Nut
• Removing and installing, see - item 17 - in the => [ Shift and Selector Cables Overview ] Shift and Selector Cables Overview.
2 Transmission Shift Lever
• Can be replaced with the gear shift unit still installed.
• Installed position, refer to => [ Transmission Shift Lever/Relay Lever Installed Position ] Shift and Selector Cables Overview.
• Installing, refer to => [ Installing the Transmission Shift Lever ] Shift and Selector Cables Overview.
• Adjust the selector mechanism after installation. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.
3 Sliding Shoe
• Clips into the relay lever.
4 Bushing
• Not needed for the plastic relay lever.
5 Relay Lever
• Installed position, refer to => [ Transmission Shift Lever/Relay Lever Installed Position ] Shift and Selector Cables Overview.
• Adjust the selector mechanism after installation. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.
• Plastic relay lever as of 03.07. Refer to => [ Plastic Relay Lever ] Plastic Relay Lever.
6 Gear Shift Unit
• Consisting of the gear shift shaft and the gear shift cover.
• The components cannot be separated from each other.
• Can be removed and installed with the transmission installed.
• Gear shift shaft adapted together with the revised reverse gear selector fork bearing, see - item 5 - in the => [ Selector Forks ] Selector Forks.
• Allocation, gear shift shafts.
7 Bushing
• For the selector shaft
• Removing and installing, see - item 16 - in the => [ Transmission Housing ] Transmission Housing.
8 O-ring
• Insert in the groove in the gear shift unit cover.
• Install using transmission fluid.
• Always replace.
9 Cap
• For the transmission ventilation.
10 Lock Washer
• For the relay lever
• Not needed with the plastic relay lever.
11 Selector Shaft Seal
• Removing and installing, refer to => [ Selector Shaft Seal ] Selector Shaft Seal.
Allocation, Gear Shift Shafts
