Plastic Relay Lever

Plastic Relay Lever

From 03.07 - Plastic Relay Lever





• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.

This prevents damage to the selector cable.






- Pull the locking mechanism all the way forward in the - direction of arrow 1 - and then unlock it to the left in the - direction of arrow 2 -.

- Press the relay lever forward, in the - direction of arrow 3 -.

Relay Lever with a Tab (see illustration N34-10903)

- Press the tab - arrow 1 - down and remove the relay lever together with the cable retainer. Move it in the operating direction when doing so.

Relay Lever with a Clip





- Remove the clip - arrow 1 - and the relay lever together with the cable retainer.

Continuation for All

The cable retainer must be behind the tab - arrow 2 -.

• The cable retainer may only be removed with the relay lever removed.

• When installing, lubricate the following areas very carefully.






• Relay lever shaft - A - - arrows -.

• Transmission shift lever guide rail - B -, fits into the relay lever.






• The relay lever and transmission shift lever in the illustration may differ from the original part.

• Grease allocation, refer to the Parts Catalog.

- Press the cable retainer on the relay lever.

- Insert the relay lever together with the cable retainer as far as the stop.

Relay Lever with a Tab (see illustration N34-10903)

• The tab - arrow 1 - secures the relay lever.

• Make sure it engages securely.

• The cable retainer must be behind the tab - arrow 2 -.

Relay Lever with a Clip (see illustration N34-11141)

• The clip - arrow 1 - secures the relay lever.

• Make sure the clips locks securely.

• The cable retainer must be behind the tab - arrow 2 -.

Removing the Selector Cable Retainer from the Plastic Relay Lever





• The relay lever is removed

- Insert a flat blade screwdriver - A - between the bushing - B - and the relay lever.

Installing the Cable Retainer





• The relay lever is removed

• The cable retainer may only be installed at the bushing - arrow -.

• The cable retainer must move freely on the relay lever.

• It must be behind the tab - arrow 2 -.