Evaporative Emission System Assembly Overview

Evaporative Emission System Assembly Overview





1 Evaporative Emission (EVAP) Filter

• Only installed with engine codes BGQ and CBUA.

2 Bolt

• 8 Nm

3 Bushing

4 Evaporative Emission (EVAP) Canister

• Installed location: in the bottom of the spare wheel well.

• Removing and installing, refer to => [ Evaporative Emission Canister ] Evaporative Emission Canister.

5 Nut

• 6 Nm

6 Bracket

7 Support

8 Bracket

9 Bolt

• 4 Nm

10 Rubber Grommet

11 Washer

12 Bolt

• 8 Nm

13 Vent Line

• To the engine.

14 Leak Detection Pump (LDP) (V144)

• Installed location: under the wheel housing liner in the right rear wheel housing.

• Checking, refer to the vehicle diagnosis, testing and information system VAS 5051.

• Removing and installing, refer to => [ Leak Detection Pump ] Service and Repair.

15 Bolt

• 4 Nm

16 Connecting Hose

17 Clamp

18 Air Filter Housing

• For the LDP.

• No maintenance schedule.

19 Bracket

20 Connecting Pipe

• Clipped in on the bracket.

• To disconnect, press release button on connection piece.

21 Vent Line

• To fuel tank filler tube.

• To disconnect, press release button on connection piece.

22 Vent Line

• To disconnect, press release button on connection piece.

23 Vent Line

• To the EVAP canister purge regulator valve.

• To disconnect, press release button on connection piece.