Shift Solenoid: Service and Repair

Solenoid Valve and Sensor Wiring Harness

Removing

- Drain the Automatic Transmission Fluid (ATF). Refer to => [ Draining and Filling ] Testing and Inspection.

- Remove the oil filter. Refer to => [ Transmission Fluid Filter ] Service and Repair.

- Remove the valve body. Refer to => [ Valve Body ] Valve Body.

- Disconnect the electrical connectors from the transmission.

- 1 - transmission sensor terminal

- 2 - connector for solenoid valves





- Disconnect the connector housing from the transmission.

- Disconnect the connector housing together with the wiring harness outward from the transmission housing.

Installing

- Replace the seal on the connector housing.

- Carefully guide the wiring harness from the outside into the transmission.

- Lubricate the connector housing seal with ATF and then press the connector housing all the way into the transmission.

- Connect the connector housing; tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications.

- Install the valve body. Refer to => [ Valve Body ] Valve Body.

- Install the oil filter. Refer to => [ Transmission Fluid Filter ] Service and Repair.

- Add ATF, check the ATF level and top off. Refer to => [ ATF Level, Checking and Filling ] Testing and Inspection.