Clutch, Removing

Clutch, Removing

To remove and install the clutch, the transmission must be secured in a vertical position on the assembly stand.

- Remove the clutch end cover. Refer to => [ Clutch Cover, Removing ] Clutch Cover, Removing.

- Remove the circlip - arrow -.





This circlip must be measured and replaced later when installing.

CAUTION!
Carefully remove the clutch. Make sure that the end cover or other parts of the clutch do not fall out! Do not turn the clutch over!

If this happens, refer to => [ Special Care ] Clutch, Installing and Adjusting.

- Remove the clutch.





- Remove the pump shaft - A -.





- The pump shaft is inserted only after the installation of the new clutch. Set the shaft aside until then.