Installation

BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
* The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR

(a) Install rear axle hub and bearing assembly with skid control sensor Installation.

HINT
* The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

4. INSTALL REAR DISC Reassembly

5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Reassembly

6. CONNECT SKID CONTROL SENSOR WIRE

(a) Connect the connector to the skid control sensor.





7. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

HINT
Rear Wheel Alignment

9. CHECK SPEED SENSOR SIGNAL

HINT
* for BOSCH Test Mode Procedure
* for ADVICS Test Mode Procedure