Installation (to 12/2010)

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the crankshaft position sensor connector.

2. INSTALL COOLER COMPRESSOR ASSEMBLY Installation (to 12/2010)

3. INSTALL GENERATOR ASSEMBLY Installation (to 12/2010)

4. INSTALL V-RIBBED BELT Installation (to 12/2010)

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.