Removal (from 12/2010)

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE V-RIBBED BELT Removal (from 12/2010)

3. REMOVE GENERATOR ASSEMBLY Removal (from 12/2010)

4. DISCONNECT COOLER COMPRESSOR ASSEMBLY Removal (from 12/2010)

5. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.





(b) Remove the bolt and crankshaft position sensor.