Engine Control Module: Service and Repair

REMOVAL

(a) Remove the finish lower center panel.
(b) Remove the 3 bolts and disconnect the ECM.
(c) Disconnect the following connector:
- 3 ECM connectors
- 5 connectors from connectors on bracket
- Heated oxygen sensor (bank1 sensor2) connector

INSTALLATION

(a) Connect the following connectors:
- 3 ECM connectors
- 5 connectors from connectors on bracket
- Heated oxygen sensor (bank1 sensor2) connector
(b) Connect the ECM and install the 3 bolts.
(c) Install the finish lower center panel.