Installation

AIR CONDITIONING: PTC HEATER ASSEMBLY: INSTALLATION

1. INSTALL PTC HEATER ASSEMBLY





(a) Install the PTC heater with the 2 screws.

(b) Connect the connector and 2 clamps.

2. INSTALL NO. 1 AIR DUCT





(a) Engage the 3 claws and install the air duct.

3. INSTALL INSTRUMENT PANEL BRACE SUB-ASSEMBLY Installation

4. INSTALL REAR NO. 2 AIR DUCT Installation

5. INSTALL STEERING COLUMN ASSEMBLY Installation

6. INSTALL BRAKE PEDAL SUPPORT Installation

7. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS Installation

8. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY Installation

9. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation

10. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT Installation

11. CONNECT POWER STEERING ECU ASSEMBLY Installation

12. INSTALL COMBINATION SWITCH ASSEMBLY Installation

13. INSTALL STEERING COLUMN UPPER COVER Installation

14. INSTALL STEERING COLUMN LOWER COVER Installation

15. INSTALL STEERING WHEEL ASSEMBLY Installation

16. INSTALL STEERING PAD Installation

17. INSTALL LOWER INSTRUMENT PANEL Installation

18. CONNECT ANTENNA CORD SUB-ASSEMBLY Installation

19. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation

20. INSTALL NO. 1 RADIO BRACKET Installation

21. INSTALL NO. 2 RADIO BRACKET Installation

22. INSTALL INSTRUMENT PANEL BOX Installation

23. INSTALL INSTRUMENT PANEL UNDER TRAY Installation

24. INSTALL FRONT CONSOLE BOX Installation

25. CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY Installation

26. CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY Installation

27. CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY Installation

28. INSTALL AIR CONDITIONING PANEL ASSEMBLY Installation

29. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY Installation

30. INSTALL CONSOLE BOX CARPET Installation

31. INSTALL REAR CONSOLE BOX COVER Installation

32. INSTALL UPPER CONSOLE PANEL Installation

33. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation

34. INSTALL COWL SIDE TRIM BOARD RH Installation

35. INSTALL COWL SIDE TRIM BOARD LH Installation

36. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

37. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

38. INSTALL FRONT DOOR SCUFF PLATE RH Installation

39. INSTALL FRONT DOOR SCUFF PLATE LH Installation

40. INSTALL UPPER INSTRUMENT PANEL Installation

41. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

42. INSTALL INSTRUMENT CLUSTER FINISH PANEL RETAINER Installation

43. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY Installation

44. INSTALL COMBINATION METER ASSEMBLY Installation

45. INSTALL INSTRUMENT CLUSTER FINISH PANEL Installation

46. INSTALL FRONT PILLAR GARNISH RH Installation

47. INSTALL FRONT PILLAR GARNISH LH Installation

48. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation

49. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation

50. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

51. INSPECT SRS WARNING LIGHT

Diagnosis System

52. POSITION FRONT WHEELS FACING STRAIGHT AHEAD