Installation

K41B CVT: TRANSMISSION CONTROL CABLE: INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Pass the transmission control cable into the vehicle and install the transmission control cable to the body, using the 3 bolts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

(b) Install the transmission control cable to the No. 1 transmission control cable bracket, using a new clip.

(c) Using the nut, connect the transmission control cable to the transmission control shaft lever.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

NOTICE:
Check that the park/neutral position switch is in the N position.

(d) Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.





Text in Illustration





(e) Install the transmission control cable's cable outer onto the shift lever plate.





Text in Illustration





NOTICE:
After installation, check that the cable outer stopper extends past the line A-A, as shown in the diagram.

(f) Confirm that the shift lever is in N and install the cable end to the shift lever.

NOTICE:
* Push the cable end to the base of the pin to be sure that it is installed securely.
* Install the cable end adjustment mechanism so that the lock faces the driver seat.

2. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

3. ADJUST SHIFT LEVER POSITION Adjustments

4. INSTALL REAR CONSOLE BOX ASSEMBLY

Installation