Installation

K41B CVT: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Temporarily install the park/neutral position switch with the 2 bolts.

(b) Install the nut and a new nut stopper.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(c) Temporarily install the transmission control shaft lever, rotate it counterclockwise until it stops, rotate it clockwise for 2 notches to the N position, and then remove the transmission control shaft lever.





Text in Illustration





(d) Align the neutral reference line with the protrusion on the nut stopper and fully tighten the 2 bolts.





Text in Illustration





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(e) Bend the tabs of the nut stopper with a screwdriver.

(f) Install the transmission control shaft lever and spring washer, and tighten the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(g) Connect the park/neutral position switch connector.

2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Using the nut, connect the transmission control cable to the transmission control shaft lever.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

NOTICE:
Confirm that the shift lever is in the N position.

3. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

4. ADJUST SHIFT LEVER POSITION Adjustments