Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.

1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

2. LOOSEN ADJUSTING NUT Removal

3. REMOVE REAR WHEEL

4. REMOVE REAR BRAKE DRUM Removal

5. DISCONNECT SKID CONTROL SENSOR WIRE Removal

6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

(a) Remove the 4 bolts and the rear axle hub and bearing assembly.





HINT
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.