Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU

(a) Engage the claw and install the occupant classification ECU.





NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

(b) Connect the 2 connectors.

NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

(c) Install the front seatback band.

2. INSTALL FRONT SEAT ASSEMBLY RH

Installation

3. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

Programming and Relearning

4. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

5. INSPECT SRS WARNING LIGHT

Diagnosis System