Installation

HEATING / AIR CONDITIONING: CONDENSER: INSTALLATION

1. INSTALL COOLER CONDENSER ASSEMBLY

(a) Engage the 2 claws and install the cooler condenser into the vehicle.

NOTICE:
Do not damage the condenser or radiator when installing the condenser.

HINT
If a new cooler condenser is installed, add compressor oil to the condenser as follows.

Capacity:

Add 40 cc (1.35 fl. oz.)

Compressor oil:

ND-OIL8 or equivalent.

2. INSTALL AIR CONDITIONING TUBE ASSEMBLY

(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.

(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL8 or equivalent

(c) Install the O-ring onto the air conditioning tube.

(d) Install the air conditioning tube onto the cooler condenser with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL COOLER REFRIGERANT DISCHARGE PIPE A

(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.

(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL8 or equivalent

(c) Install the O-ring onto the air conditioning tube.

(d) Install the air conditioning tube onto the cooler condenser with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

4. INSTALL RADIATOR SUPPORT EXTENSION RH

HINT
Use the same procedure as for the LH side Reassembly.

5. INSTALL NO. 1 RADIATOR SIDE AIR SEAL

HINT
Use the same procedure as for the No. 2 side Reassembly.

6. INSTALL FRONT BUMPER ENERGY ABSORBER Reassembly

7. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY Installation

8. INSTALL RADIATOR SUPPORT UPPER ABSORBER Reassembly

9. INSTALL FRONT BUMPER COVER

Installation

10. CHARGE REFRIGERANT Service and Repair

11. WARM UP ENGINE Service and Repair

12. INSPECT FOR REFRIGERANT LEAK Service and Repair