Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL SPIRAL CABLE SUB-ASSEMBLY

(a) Check that the ignition switch is turned off.

(b) Confirm that the negative battery terminal is detached.

CAUTION:
Do not begin the operation for at least 90 seconds after the negative battery terminal has been detached.

(c) Confirm that the front tires face straight forward.

(d) Confirm that the turn signal switch is in the neutral position.

NOTICE:
Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.

(e) Engage the 3 claws and install the spiral cable sub-assembly.

NOTICE:
Pull the lock pin out before installing the steering wheel when replacing the spiral cable with a new one.

(f) Connect the airbag connector.





Text in Illustration





(g) Connect the horn connector.

(h) Connect the steering angle sensor connector.

CAUTION:
* Do not remove the steering angle sensor from the spiral cable.
* If there is a malfunction in the steering angle sensor, replace the spiral cable with steering angle sensor.
2. INSTALL UPPER STEERING COLUMN COVER Installation

3. INSTALL LOWER STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE SUB-ASSEMBLY Installation

5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSTALL STEERING PAD Installation

7. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

9. INSPECT SRS WARNING LIGHT

Diagnosis System