Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Check that the ignition switch is turned off.

(b) Check that the negative battery terminal is detached.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Check that the front tires face straight forward.

(d) Check that the turn signal switch is in the neutral position.

NOTICE:
Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.

(e) Engage the 3 claws and install the spiral cable with sensor sub-assembly.

NOTICE:
Pull the lock pin out before installing the steering wheel when replacing the spiral cable with sensor sub-assembly with a new one.

(f) Connect the airbag connector.

(g) Connect the horn connector.

(h) Connect the steering angle sensor connector.

CAUTION:
* Do not remove the steering angle sensor from the spiral cable with sensor sub-assembly.
* If there is a malfunction in the steering angle sensor, replace the spiral cable with sensor sub-assembly with steering angle sensor.
2. INSTALL STEERING COLUMN UPPER COVER Installation

3. INSTALL STEERING COLUMN LOWER COVER Installation

4. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Center the spiral cable with sensor sub-assembly.





(1) Turn the spiral cable with sensor sub-assembly counterclockwise until it locks.

HINT
The spiral cable with sensor sub-assembly turns a maximum of approximately 5 times.

(2) Turn the spiral cable with sensor sub-assembly 2.5 times clockwise from its locked position and align the alignment mark.





Text in Illustration





5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSTALL STEERING PAD Installation

7. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

9. INSPECT SRS WARNING LIGHT

Diagnosis System