Installation

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: OIL COOLER: INSTALLATION

1. INSTALL NO. 2 OIL COOLER TUBE SUB-ASSEMBLY

(a) Connect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose to the radiator.





Text in Illustration





NOTICE:
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

(b) Install the No. 2 oil cooler tube sub-assembly to the radiator with the 2 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(c) Connect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose to the No. 2 oil cooler tube.

NOTICE:
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

2. INSTALL NO. 1 OIL COOLER TUBE SUB-ASSEMBLY

(a) Connect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose to the No. 2 oil cooler tube.





Text in Illustration





NOTICE:
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

(b) Connect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose to the automatic transaxle.





Text in Illustration





NOTICE:
Make sure the paint marks and pinching portion of each clip are facing the direction shown in the illustration.

(c) Install the No. 1 oil cooler tube sub-assembly with the bolt.

Torque : 12 Nm (117 kgf-cm, 8 ft-lbf)

(d) Connect the No. 1 oil cooler inlet hose, No. 1 oil cooler outlet hose, No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose to the No. 1 oil cooler tube.

NOTICE:
* Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.
* After installing the No. 1 oil cooler tube, install the clips labeled A in the illustration so that their pinching portions are facing the front of the vehicle.

3. INSTALL BATTERY CARRIER Installation

4. INSTALL BATTERY TRAY

5. INSTALL BATTERY

6. INSTALL BATTERY INSULATOR

7. INSTALL BATTERY CLAMP SUB-ASSEMBLY Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:

Toyota Genuine ATF WS

10. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL

Service and Repair