Installation

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY

(a) Install the tire pressure warning receiver assembly with the bolt.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

(b) Connect the connector.

2. INSTALL INNER LOWER ROOF SIDE GARNISH RH

Installation

3. INSTALL REAR SEAT ASSEMBLY

Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSPECT TIRE PRESSURE WARNING SYSTEM

Test Mode Procedure