Installation

2AZ-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt.

Torque : 9.0 Nm (90 kgf-cm, 80 in-lbf)

NOTICE:
Do not twist the O-ring.





(c) Install the wire harness and crankshaft position sensor connector clamp.

(d) Connect the crankshaft position sensor connector.

2. INSTALL GENERATOR ASSEMBLY





(a) Install the generator assembly with the 2 bolts.

Bolt A - Torque : 21 Nm (215 kgf-cm, 16 ft-lbf)

Bolt B - Torque : 52 Nm (530 kgf-cm, 38 ft-lbf)

(b) Install the generator wire to terminal B with the nut.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)





(c) Attach the clamp and connect the generator connector to the generator.

(d) Install the 2 wire harness clamps.

3. INSTALL FAN & GENERATOR V BELT Installation

4. INSTALL ENGINE UNDER COVER REAR RH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

6. INSPECT FOR OIL LEAK