Installation

2AZ-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL FRONT CRANKSHAFT OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.





SST : 09223-22010

NOTICE:
* Keep the lip free from foreign matter.
* Do not tap on the oil seal at an angle.
2. INSTALL CRANKSHAFT PULLEY





(a) Using SST, fix the pulley in place and tighten the bolt.

SST : 09213-54015

91651-60855

SST : 09330-00021

Torque : 180 Nm (1835 kgf-cm, 133 ft-lbf)

3. INSTALL FAN & GENERATOR V BELT Installation

4. INSPECT FOR ENGINE OIL LEAK

5. INSPECT ENGINE OIL LEVEL Testing and Inspection

6. INSTALL REAR ENGINE UNDER COVER RH

7. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)