Installation

AXLE: STEERING KNUCKLE: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL STEERING KNUCKLE
(a) Install the front disc brake dust cover onto the steering knuckle.





(b) Install the axle hub with the 4 bolts.
Torque: 96 Nm (979 kgf-cm, 71 ft-lbf)
NOTICE: Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY Installation
3. INSTALL FRONT AXLE ASSEMBLY Installation
4. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY Installation
5. INSTALL FRONT DISC Installation
6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation
7. INSTALL TIE ROD END SUB-ASSEMBLY Installation
8. INSTALL FRONT AXLE HUB NUT Installation
9. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal
10. REMOVE FRONT DISC Removal
11. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub
12. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub
13. INSTALL FRONT DISC Installation
14. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation
15. INSTALL FRONT SPEED SENSOR Installation
16. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.
18. CHECK VSC SENSOR SIGNAL
Check for Intermittent Problems