Installation

U241E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch assembly onto the manual valve lever shaft.
(b) Provisionally install the 2 bolts.





(c) Replace the lock plate with a new one and tighten the manual valve shaft nut.
Torque: 6.9 Nm (70 kgf-cm, 61 in-lbf)





(d) Provisionally install the control shaft lever.
(e) Turn the control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.
(f) Remove the control shaft lever.





(g) Align the groove with the neutral basic line.
(h) Hold the switch in this position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)





(i) Using a screwdriver, stake the nut with the lock plate.





(j) Install the control shaft lever with the nut.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)





(k) Install the transmission control cable assembly into the control shaft lever with the nut.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)





(l) Connect the connector to the park/neutral position switch assembly.
2. INSTALL NO. 2 BATTERY CARRIER Installation
3. INSTALL BATTERY Installation
4. INSPECT SHIFT LEVER POSITION On-Vehicle Inspection
5. ADJUST SHIFT LEVER POSITION Installation
6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY On-Vehicle Inspection