Installation

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION
HINT: The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL REAR SEAT OUTER BELT ASSEMBLY





(a) Check the angle of inclination required to lock the retractor.
(1) Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
NOTICE: Do not disassemble the retractor.

If the operation is not as specified, replace the rear seat outer belt.





(b) Hook the lower stay of the retractor onto the 2 body hooks and install the retractor with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)





(c) Install the through anchor with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
(d) Check that the ELR locks.
NOTICE: Perform the check with the rear seat outer belt installed.
(1) With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the rear seat outer belt.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation
4. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY
5. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation
6. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation
7. INSTALL REAR DECK TRIM COVER Installation
8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
9. INSTALL REAR DOOR SCUFF PLATE RH Installation
10. INSTALL REAR SEATBACK ASSEMBLY RH Installation
11. INSTALL REAR SEATBACK ASSEMBLY LH Installation
12. INSTALL REAR SEAT CUSHION WITH COVER PAD SUB-ASSEMBLY Installation
13. INSTALL DECK FLOOR BOX RH Installation
14. INSTALL DECK FLOOR BOX LH Installation
15. INSTALL REAR DECK FLOOR BOX Installation