FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2009 >> xB L4-2.4L (2AZ-FE) >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> Installation

Installation








SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY





(a) Confirm that the ignition switch is turned to OFF.
(b) Confirm that the negative battery terminal is detached.
CAUTION:
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
- Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.

(c) Install the 3 bolts and remove the airbag sensor.
Torque: 18 Nm (178 kgf-cm, 13 ft-lbf)
NOTICE:
- Do not use an airbag sensor that has been dropped.
- Do not subject the airbag sensor to any impact or force.
- Confirm that the carpet does not interfere with the installation plane.

(d) Confirm that there is no looseness by shaking the front airbag sensor.





(e) Connect the connector holder to lock the lever.
NOTICE: Confirm that the lever is locked.





(f) Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.
2. INSTALL SHIFT LEVER ASSEMBLY (for Automatic Transaxle) Installation
3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Automatic Transaxle) Installation
4. INSPECT SHIFT LEVER POSITION (for Automatic Transaxle) On-Vehicle Inspection
5. ADJUST SHIFT LEVER POSITION (for Automatic Transaxle) Installation
6. INSTALL SHIFT LEVER ASSEMBLY (for Manual Transaxle) Installation
7. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Manual Transaxle) Installation
8. ADJUST TRANSMISSION CONTROL SELECT CABLE (for Manual Transaxle)
9. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL
10. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
11. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
12. INSTALL INSTRUMENT CLUSTER FINISH CENTER LOWER PANEL Installation
13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
15. INSPECT SRS WARNING LIGHT
Diagnosis System
pro multis Credits:Operation CHARM About Operation CHARM