Installation

2AZ-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
NOTE: Make sure that the O-ring is not cracked or jammed when installing.





(a) Apply a light coat of engine oil to the O-ring of the sensor.






(b) Install the sensor with the bolt.
Torque: 9.0 Nm (90 kgf-cm, 80 in-lbf)
(c) Install the wire harness clamp.
(d) Install the connector clamp.
(e) Connect the sensor connector.
(f) Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
2. INSTALL GENERATOR ASSEMBLY Installation

3. INSTALL FAN AND GENERATOR V BELT Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. CHECK FOR ENGINE OIL LEAKAGE
6. INSTALL FRONT FENDER APRON SEAL RH Installation

7. PERFORM INITIALIZATION
(a) Perform initialization Testing and Inspection.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.