Vent Control Cables Replacement
Vent Control Cables ReplacementREMOVAL PROCEDURE
IMPORTANT: Note the routing position of the cable in order ensure easy installation.
1. Disconnect the fresh/recirc control cable (3) at the blower case (4).
2. Remove the heater control unit (5).
3. Disconnect the fresh/recirc control cable at the heater control unit.
4. Remove the fresh/recirc control cable from the Instrument Panel (IP)
INSTALLATION PROCEDURE
1. Position the fresh/recirc control cable (3) in the vehicle. Correctly route the cable.
2. Connect the fresh/recirc control cable to the heater control unit (5).
3. Install the heater control unit to the IP. Refer to Control Assembly Replacement. Control Assembly Replacement
4. Connect the fresh/recirc control cable to the blower case (4).
5. Adjust the fresh/recirc control cable. Refer to Vent Control Cable adjustment Vent Control Cable Adjustment