Removal And Installation

EXHAUST MANIFOLD

Removal and Installation


REMOVAL

1.Remove cowl top. Service and Repair.
2.Remove exhaust front tube. Component.
3.Remove exhaust manifold cover.





4.Remove the air fuel ratio sensor 1, using Tool (A).
Tool number: KV-991J0050 (J-44626)

CAUTION:
Handle it carefully and avoid impacts.
5.Remove exhaust manifold side bolt of exhaust manifold stay.





6.Loosen nuts in reverse order as shown and remove exhaust manifold.






CAUTION:
Cover engine openings to avoid entry of foreign materials.

INSPECTION AFTER REMOVAL

Surface Distortion





- Using straightedge (B) and feeler gauge (A), check the surface distortion of exhaust manifold mating surface in each exhaust port and entire part.






INSTALLATION






1.Install exhaust manifold gasket to cylinder head as shown.

CAUTION:
Do not reuse gasket.










2.Tighten exhaust manifold nuts to specification in two stages in the numerical order shown.










3.Install exhaust manifold stay (2) in the direction as shown.










4.Install the air fuel ratio sensor 1, using Tool (A).
Tool number: KV-991J0050 (J-44626)

CAUTION:
- Handle it carefully and avoid impacts.
- Before installing a new air fuel ratio sensor, clean the exhaust tube threads using suitable tool and approved anti-seize lubricant.
- Do not over-tighten the air fuel ratio sensor. Doing so may damage the air fuel ratio sensor, resulting in the MIL coming on.
Oxygen sensor thread cleaner: (J-43897-12)
Oxygen sensor thread cleaner: (J-43897-18)

5.Installation of the remaining parts is in the reverse order of removal.