Cowl Moulding / Trim: Service and Repair

COWL TOP

Removal and Installation












REMOVAL

1.Remove front wiper arm RH/LH from vehicle. Front Wiper Arms.





2.Disconnect washer tube.
3.Remove fender seal and fender cover RH/LH.
4.Release the cowl top seal clips, then remove cowl top seal.





5.Release the cowl extension clip (1) by prying the center pawls apart and pulling clip outward. Remove remaining clips, then remove cowl top cover (2).





6.Disconnect and remove the front wiper motor and linkage assembly. Service and Repair.

CAUTION:
To avoid damage, make sure to cover the lower edge of windshield with suitable protection material.
7.Remove cowl extension panel bolts, then remove cowl extension panel.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
- For wiper arm RH/LH installation and adjustment, Front Wiper Arms.
- Always replace EPT sealer and double-faced adhesive tape when installing cowl top cover.