Removal and Installation

ALTERNATOR

Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal. Removal And Installation.
2.Remove charge air cooler. Removal And Installation.
3.Remove drive belt. Removal And Installation.
4.Disconnect alternator connector.
5.Remove "B" terminal nut and disconnect "B" terminal harness.
6.Remove alternator mounting bolt (upper).
7.Completely loosen alternator mounting bolt (lower), and pull it out until the bolt head is in contact with the side member. And then, remove the alternator by pulling it forward.
NOTE:
The alternator can be removed together with the bolts by pulling it forward and using the thermostat housing bolt hole cutout.
8.Remove alternator forward from the vehicle.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Temporarily tighten the alternator bolts in order from the lower to the upper, and then tighten them in order from the upper to the lower.
- For the alternator, the front side (pulley side) surface is the reference surface. Fit the reference surface to the alternator mounting part, and then tighten the bolts.
- Be careful to tighten "B" terminal nut carefully.
- Install alternator, and check tension of belt. Inspection.
- For this model, the power generation voltage variable control system that controls the power generation voltage of the alternator has been adopted. Therefore, the power generation voltage variable control system operation inspection should be performed after replacing the alternator, and then make sure that the system operates normally. Power Generation Voltage Variable Control System Operation Inspection.