Removal And Installation Sedan

FLOOR TRIM

Removal and Installation


REMOVAL

1.Remove front seats (RH/LH) and rear seat cushion. Sedan and Sedan.
2.Remove front kicking plates (RH/LH), dash side lower finishers (RH/LH), rear kicking plates (RH/LH), and center pillar lower finishers (RH/LH). Removal And Installation Sedan.
3.Remove center console. Removal And Installation.
4.Remove the glove box assembly. Service and Repair.





5.Remove the connector ducts (RH/LH) (2) and the center connector duct (1) from heater and cooling unit. Ducts, Nozzles And Grilles.





6.Remove the bracket bolt, then position the parking brake cable aside.
7.Disconnect the drain hose (4) from the heater and cooling unit, then set aside.
8.Remove the three bolts (A) and one nut, then remove the bracket (3).
9.Remove the driver air bag module. Removal And Installation.
10.Disconnect the passenger air bag module. Front Passenger Air Bag Module.
11.Disconnect the side curtain air bag modules. Removal And Installation.
12.Remove the diagnosis sensor unit. Service and Repair.





13.Remove the parking brake cable nuts (A), then position the parking brake cables (2) aside.





14.Remove the bracket nuts (B), then remove extension bracket (1) and center console rear bracket (3).
15.Remove front seat belt floor anchor bolt (RH/LH). Exploded View.
16.Release the tab, then remove floor mat hooks.
17.Release the tabs and open harness clamps (seven-RH and seven-LH). Position harness and floor carpet cut-out areas outside of harness clamps.
INT
18.Fold corners toward center, then remove floor carpet.

INSTALLATION

Installation is in the reverse order of removal.