Removal And Installation

TRANSVERSE LINK

Removal and Installation


REMOVAL

1.Remove tires with power tool. Refer to "Exploded View" Exploded View.
2.Separate stabilizer connecting rod from strut assembly. Refer to "Removal and Installation" Removal And Installation.
3.Separate steering outer socket from steering knuckle.
- With heated steering wheel: Refer to "Removal and Installation" With Heated Steering Wheel.
- Without heated steering wheel: Refer to "Removal and Installation" Without Heated Steering Wheel.
4.Remove transverse link from steering knuckle with power tool. Refer to "Removal and Installation" Removal And Installation.
5.Remove transverse link from suspension member with power tool.
NOTE:
To remove transverse link mounting nut, move stabilizer bar.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Never reuse transverse link mounting nut.
- Perform final tightening of fixing parts at the vehicle installation position (rubber bushing), under unladen conditions with tires on level ground.
- Perform inspection after installation. Refer to "Inspection" Inspection.