Shift Indicator - CVT: Testing and Inspection

CVT INDICATOR


CVT Indicator Does Not Illuminate

1. CHECK SEGMENT OF CVT INDICATOR





Perform self-diagnosis of combination meter. Refer to Self-Diagnosis Mode of Combination Meter
Are all segments displayed?
YES >> GO TO 2.
NO >> Replace combination meter. Refer to Removal And Installation.
2. CHECK COMBINATION METER (CONSULT-III)
1. Connect CONSULT-III.
2. Select "METER/M&A" on CONSULT-III, and perform self-diagnosis of combination meter. Refer to Scan Tool Testing and Procedures.
Self-diagnostic results content
No malfunction detected>> GO TO 3.
Malfunction detected>> Check applicable parts, and repair or replace as necessary.
3. CHECK COMBINATION METER INPUT SIGNAL
Use "DATA MONITOR" of "METER/M&A" on CONSULT-III. Confirm each indication on the monitor while operating the CVT selector lever.





OK or NG
OK >> Replace combination meter. Refer to Removal And Installation.
NG >> GO TO 4.
4. CHECK SELF-DIAGNOSIS RESULTS OF TCM
Perform self-diagnosis of TCM. Refer to CONSULT-III Function (Transmission).
OK or NG
OK >> Check TCM input/output signal. Repair or replace malfunctioning part, if necessary. Refer to TCM Input/Output Signal Reference Value.
NG >> Check applicable part, and repair or replace as necessary.