Vehicle Does Not Creep Backward In "R" Position
Vehicle Does Not Creep Backward in "R" PositionSYMPTOM:
Vehicle does not creep backward when selecting "R" position.
DIAGNOSTIC PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to CVT-46, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
Is any malfunction detected by self-diagnosis
YES >> Check the malfunctioning system. Refer to CVT-46, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
NO >> GO TO 2.
2.CHECK CVT POSITION
Check CVT position. Refer to CVT-173, "Checking of CVT Position". Testing and Inspection
OK or NG
OK >> GO TO 3.
NG >> Adjust CVT position. Refer to CVT-173, "Adjustment of CVT Position". Adjustments
3.CHECK CVT FLUID LEVEL
Check CVT fluid level. Refer to CVT-14, "Checking CVT Fluid". Changing CVT Fluid
OK or NG
OK >> GO TO 4.
NG >> Refill CVT fluid.
4.CHECK LINE PRESSURE
Check line pressure at idle. Refer to CVT-35, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
OK or NG
OK >> GO TO 5.
NG >> Check the malfunctioning item. Refer to CVT-35, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
5.CHECK STALL REVOLUTION
Check stall revolution. Refer to CVT-35, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
OK or NG
OK >> GO TO 6.
NG >> Check the malfunctioning item. Refer to CVT-35, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
6.CHECK SYMPTOM
Check again. Refer to CVT-39, "Check at Idle". Check at Idle
OK or NG
OK >> INSPECTION END
NG >> GO TO 7.
7.CHECK TCM
1. Check TCM input/output signals. Refer to CVT-44, "TCM Input/Output Signal Reference Value". Pinout Values and Diagnostic Parameters
2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace the transaxle assembly.
NG >> Repair or replace damaged parts.