Procedure 5

Final Checking After Repairing SRS By Using "AIR BAG" Warning Lamp - Diagnosis Mode And User Mode

1. After repairing SRS connect both battery cables.

Diagnostic Procedure 5 (without Consult):

2. Open driver's door.
3. Turn ignition switch from OFF to ON.

Diagnostic Procedure 5 (without Consult):

4. "AIR BAG" warning lamp operates in Diagnosis mode as above.
5. If "AIR BAG" warning lamp operates as shown in No. 1 in the chart above, turn ignition switch OFF to reset from Diagnosis mode to User mode, then go to step 6.

If "AIR BAG" warning lamp operates as in No. 2 in chart above, the malfunctioning part is not repaired completely, or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 3 and repair malfunctioning part completely.

6. Turn ignition switch ON. "AIR BAG" warning lamp operates in User mode. Compare "AIR BAG" warning lamp operation to the chart above.

NOTE: If switching Diagnosis mode to User mode is required while malfunction is being detected, turn ignition switch from OFF to ON. Then press driver's door switch at least 5 times within 7 seconds after turning ignition switch ON.
SRS is now in User mode.