Procedure 2

Inspecting SRS Malfunctioning Parts By Using CONSULT - Diagnosis Mode

Diagnostic Procedure 2 (with Consult):

1. Turn ignition switch OFF.
2. Connect CONSULT to data link connector.

Diagnostic Procedure 2 (with Consult):

3. Turn ignition switch ON.
4. Touch START

Diagnostic Procedure 2 (with Consult):

5. Touch AIRBAG.

Diagnostic Procedure 2 (with Consult):

6. Touch SELF-DIAG [CURRENT].

Diagnostic Procedure 2 (with Consult):

7. Diagnostic codes are displayed on SELF-DIAG [CURRENT].

Diagnostic Procedure 2 (with Consult):

^ If no self-diagnostic failure is detected on SELF-DIAG [CURRENT] even though a malfunction is detected in DIAGNOSTIC PROCEDURE 1, go to DIAGNOSTIC PROCEDURE 6.

8. Touch PRINT
9. Compare diagnostic codes to the CONSULT DIAGNOSTIC CODE CHART
10. Touch BACK key of CONSULT until SELECT SYSTEM MODE appears, then turn off CONSULT
11. Turn ignition switch OFF, then disconnect CONSULT and both battery cables.
12. Repair the system as outlined by the Repair order that corresponds to the problem code in CONSULT DIAGNOSTIC CODE CHART For replacement procedure of component parts.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4.

Consult Diagnostic Code Chart:

CONSULT DIAGNOSTIC CODE CHART