G1 - Belt to A-Pillar

^ Install jumpers in passive restraint module mating connector.

- Passenger--pin 9 (circuit 865, P/W) to pin 6 (circuit 57, BK) and pin 22 (circuit 865, P/W) to pin 19 (circuit 57, BK).

- Driver--pin 3 (circuit 860, P/Y) to pin 7 (circuit 38, BK/O) or pin 4 (circuit 860, P/Y) to pin 20 (circuit 38, BK/O)

- Passenger--pin 10 (circuit 864, O) to pin 7 (circuit 38, BK/O) or pin 11 (circuit 864, O) to pin 20 (circuit 38, BK/O).

^ Motor directs drive belt toward A-pillar -- Go to G2. G2 - Belt to B-Pillar

^ Motor does not run -- Check fuse. Check motor circuit breaker. Check wiring to motor. Service if necessary. Repeat G1. G1 - Belt to A-Pillar

-- If motor still does not run, go to G3. Install original passive restraint module. G3 - Motor Resistance Check