G2 - Belt to B-Pillar

^ Install jumpers in mating connector.

- Passenger -- pin 10 (circuit 864, O) to pin 6 (circuit 57, BK) and pin 11 (circuit 864, O) to pin 19 (circuit 57, BK).

- Driver -- pin 2 (circuit 861, BK/W) to pin 7 (circuit 38, BK/O) or pin 17 (circuit 861, BK/W) to pin 20 (circuit 38, BK/O)

- Passenger -- pin 9 (circuit 865, P/W) to pin 7 (circuit 38, BK/O) or pin 22 (circuit 865, P/W) to pin 20 (circuit 38, BK/O).

^ Does motor run toward B-pillar?

YES -- System OK.

NO -- Check fuse. Check motor circuit breaker. Check wiring to motor. Service if necessary. Repeat this test. If motor does not run, go to G3. Install original passive restraint module. G3 - Motor Resistance Check