Removal

SUSPENSION: FRONT UPPER SUSPENSION ARM (for 2WD): REMOVAL

NOTICE:
Be sure to read the "PRECAUTION" thoroughly before servicing Suspension Control System.

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

3. REMOVE FRONT WHEEL

4. DISCONNECT SPEED SENSOR CONNECTOR Removal

5. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

6. REMOVE FRONT DISC Removal

7. REMOVE FRONT DISC BRAKE DUST COVER LH Removal

8. DISCONNECT TIE ROD ASSEMBLY LH Removal

9. DISCONNECT FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH Removal

10. DISCONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Removal

11. REMOVE FRONT STABILIZER LINK ASSEMBLY LH Removal

12. REMOVE AIR CONNECTOR CLIP HOLDER (w/ Air Suspension) Removal

13. DISCONNECT NO. 8 HEIGHT CONTROL TUBE (w/ Air Suspension) Removal

14. DISCONNECT FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH Removal

15. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

16. REMOVE ENGINE ROOM SIDE COVER LH Removal

17. REMOVE FRONT SHOCK ABSORBER CAP LH (w/ Air Suspension) Removal

18. REMOVE ABSORBER CONTROL ACTUATOR (w/ Air Suspension) Removal

19. REMOVE FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension) Removal

20. REMOVE PNEUMATIC FRONT LH WITH SHOCK ABSORBER CYLINDER ASSEMBLY (w/ Air Suspension) Removal

21. REMOVE FRONT PNEUMATIC CYLINDER LH O-RING (w/ Air Suspension) Removal

22. REMOVE STEERING KNUCKLE SUB-ASSEMBLY LH Removal

23. REMOVE NO. 1 ARM ATTACHMENT PLATE INNER LH

(a) Remove the 3 bolts and No. 1 arm attachment plate inner LH.





24. REMOVE NO. 2 ARM ATTACHMENT PLATE INNER LH

(a) Remove the 2 bolts and No. 2 arm attachment plate inner LH.





25. REMOVE FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH

(a) Remove the bolt and nut, and then remove the front No. 1 suspension upper arm assembly LH from the No. 1 arm attachment plate inner LH.

26. REMOVE FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH

(a) Remove the bolt and nut, and then remove the front No. 2 suspension upper arm assembly LH from the No. 2 arm attachment plate inner LH.